RugerSociety.com

Got it, very nice. Makes such a clean display.

Thanks much, Rod!
TomD

I made so many of these all by hand and a pair of flat nose pliers.....
got done and my hands were blistered and bleeding.....
I bought the brass rod from Graingers ask for the bulk price as I got twice as much for less money.....

Ok Rod, my first prototype…. It works but not sure I got it like you said.
TomD

Looks good I will try and post a picture of mine soon.

Looking good Tom!!
I do not have any ability or the patience to do something like that, good for you.
I have to buy mine.....

Cheers,
Jay

I use a similar system for my guns using Slat Walls. Sorry, don't have close up pictures (probably should do that to show the holders better)

JAYDAWG wrote: ↑Wed Aug 27, 2025 6:48 pm Looking good Tom!!
I do not have any ability or the patience to do something like that, good for you.
I have to buy mine.....

Cheers,
Jay

That looks good and easy.....just how I like it
The hooks would have cost me more than the guns.....

My stands.....One 90 and one 45

Love it, Rod. Even simpler. I’ll try that next. Also thinking to see if I can put clear tubing over the end and still fit it in a 22 cylinder.

Love the slat wall ideas, I just don’t have my entire room climate controlled enough to have guns out like that.

Jay, I’m almost 100% on purchased hangers also right now, just getting tired of buying more and more. Once you retire time is more available, so time to tinker.

TomD

you can adjust the droop of the barrel for different lengths by the angle of the end that fits in to the cylinder too.....
I have 10" 44's hanging on this same rod....