SOLD - RUGER SINGLE-SIX .327 MAG. HAMILTON BOWEN BUILT
Posted: Thu Sep 01, 2016 1:52 pm
Unique Ruger Single-Six .327 Federal Magnum built by Master gunsmith Hamilton Bowen. Began its life as a 9-1/2" .32 H&R Magnum. Hamilton made the .327 Cylinder, installed the stainless Bisley grip frame, Bisley hammer & trigger, Belt Mountain knurled locking base pin and Bowen rear sight. Great action job! This revolver was test fired and regulated by Bowen and has not been fired since. This is a fine one-of-a-kind Ruger single action built by an outstanding master gunsmith. Avoid a six month plus wait to have Hamilton build one and enjoy this unique .327 Magnum...a great cartridge!!
$2,150 shipped & insured FFL to FFL. Sorry, FFL will not ship to CA or other prohibitive states (to avoid any problems, please check your State's gun laws). The asking price is about the sum of the initial gun cost, parts and gunsmithing work when built back in 2007. Payment plan of 90 days available at 1/3 down and 1/3 each the next two months.
First I'll take it followed-up by a PM gets it.
FT44/Bill
$2,150 shipped & insured FFL to FFL. Sorry, FFL will not ship to CA or other prohibitive states (to avoid any problems, please check your State's gun laws). The asking price is about the sum of the initial gun cost, parts and gunsmithing work when built back in 2007. Payment plan of 90 days available at 1/3 down and 1/3 each the next two months.
First I'll take it followed-up by a PM gets it.
FT44/Bill