Robbing medallions off MKIV grips?

Includes .22 Standard, Mark I, Mark II, Mark III and all Centerfire Semi-Auto Pistols.
Post Reply
Posts: 430
Joined: Sat Jun 07, 2014 4:19 pm
Location: North Texas

Robbing medallions off MKIV grips?

Post by RocDoc » Fri Mar 06, 2020 1:06 am

Replaced the plastic grips on a MkIV, is it possible to remove medallions to be able to use them elsewhere? Can't tell how attached.

Fox Mike
Posts: 89
Joined: Wed Jul 02, 2014 4:43 am
Location: Webster, Maryland

Re: Robbing medallions off MKIV grips?

Post by Fox Mike » Fri Mar 06, 2020 7:13 am

Find a punch that is the size of the inside of the medallion and place the grip on a rolled ;up towel and GENTLY tap and push the medallion from the back. They will come out. I have used them on other installations with no problem.I drill the holes with a brad point drill bit of the correct size as the OD of the medallion. I install them using clear RTV. never a problem.
This is one:

Here are two more:
Retired: 67Z5M
Maryland Shall Issue

Posts: 1424
Joined: Tue May 06, 2014 2:31 pm
Location: Alabama

Re: Robbing medallions off MKIV grips?

Post by flattop44 » Fri Mar 06, 2020 3:20 pm

I have taken them out of various sets of grips by "drilling" the staked ears off the medallion stake on the inside very gently with the correct size drill bit. They will then press out easily. Then glue them in the next set without having to enlarge the existing hole if you removed a set from them.


Post Reply