Page 1 of 1

Re: Merry Christmas

Posted: Thu Dec 25, 2014 11:22 am
by flattop44
Wishing the same for you X1....and many, many more!!

Re: Merry Christmas

Posted: Thu Dec 25, 2014 5:44 pm
by Trapper79
Merry Christmas to all my fellow ROCS friends. I hope Santa brings all of you that special Ruger that we have always wanted !

Re: Merry Christmas

Posted: Thu Dec 25, 2014 11:20 pm
by RUGER1441
Merry Christmas, it sure has been an interesting first year for the ROCS organization, congratulations to all for a very successful year. Next year will just get better.

Re: Merry Christmas

Posted: Fri Dec 26, 2014 1:23 pm
by SteveRuger
Got the calendar out & planning next years Gun Shows, Hunting Trips & Vacations! Dang I guess I better leave some time to WORK to pay for all this! :roll: :roll: :roll:

Re: Merry Christmas

Posted: Fri Dec 26, 2014 2:28 pm
by Brass Frame
Thanks for all the well wishes. I was very fortunate in 2014 to find an "A" prefix 10" barrel, .357 Flat Top. I also have been very fortunate to obtain a set of three, early two digit guns that are all NIB with shippers! I have friends who were willing to "share" their pieces. ROCS is well along and I am working on the second issue! Send me your articles and pictures! Brass Frame/Lee Happy New Year.

Re: Merry Christmas

Posted: Sat Dec 27, 2014 1:17 pm
by Mike722
Merry Christmas!! Santa brought me a very nice one just a few days before Christmas ;)

Re: Merry Christmas

Posted: Sat Dec 27, 2014 1:20 pm
by Hawkeye28
MERRY CHRISTMAS AND A SAFE HAPPY NEW YEARS TO ALL. BROTHER FINDLEY HAS MY ARTICLE FOR THE NEXT ISSUE, AND WE ARE WORKING ON ONE FOR THE NEXT ISSUE AFTER THAT. WE HAVE LOTS OF IDEAS AND MATERIALS! EVERYONE NEEDS TO JOIN IN! 8-)

Re: Merry Christmas

Posted: Sun Dec 28, 2014 8:16 am
by contender
A belated Merry Christmas as well! Plus a big wish for a Happy New Year! Deer season has kept me occupied & not as active on the forums as much. The ROCS is a wonderful new addition to our enjoyment of Rugers & I see it doing quite well for many years to come. I'm trying to finish off an article for the next journal myself!