Page 1 of 1
GKNR Single Six XR3 RED grip frame
Posted: Sat Nov 06, 2021 10:09 am
by Ruger8r
Looking for the regular size XR3 RED grip frame for a high-polish New Model stainless Single Six.
Re: GKNR Single Six XR3 RED grip frame
Posted: Sat Nov 06, 2021 10:33 pm
by RocDoc
Dremel and flitz can make that nausating high polish in a cuple hours or less on a grip frame, ask me how I know this.I have a SS XR3-Red off a Blackhawk I would like to send down the road
Re: GKNR Single Six XR3 RED grip frame
Posted: Wed Nov 10, 2021 2:24 pm
by Ruger8r
Intriguing offer, RocDoc. I could probably do that although I'd rather not spend the time and not sure I can match the finish. This is to restore a collectable piece that someone swapped out to a short grip frame.
Just in case, though, is it likely to fit up nicely on the Six? What are you asking for it?
Owen
Re: GKNR Single Six XR3 RED grip frame
Posted: Tue Nov 16, 2021 5:26 pm
by RocDoc
Came off an unfired NM Blackhawk I converted to bisley, fit to any cylinder frame may require a small tweek or two even though both factory. Just the slight differences within tolerances. I would take $85 flate rate priority shipped.
Re: GKNR Single Six XR3 RED grip frame
Posted: Tue Dec 07, 2021 8:00 pm
by Ruger8r
Sorry for ghosting you, RocDoc. Been a little nuts around here.
Great price and very tempting. Do the Blackhawk frames taper like the Single Six?