Page 1 of 1
Steel/Alloy ejection assembly ? Blackhawk
Posted: Sun Aug 25, 2024 8:14 pm
by Chinook3
I ran across a steel assembly are they after market? What models offered them? I assume they are preferred to alloy?
Re: Steel/Alloy ejection assembly ? Blackhawk
Posted: Mon Aug 26, 2024 9:56 am
by flattop44
Steel ERH were on the early single-action revolvers. They later went to alloy/aluminum, I believe around 1962/63. There are aftermarket steel housings out there. The .44 Flattop that you are changing the safety conversion on should have had a steel ERH.
FT44
Re: Steel/Alloy ejection assembly ? Blackhawk
Posted: Mon Aug 26, 2024 12:45 pm
by Chinook3
Well it’s in like new condition and I was thinking of using it. But I am working on a 1966 .41 mag Blackhawk.
We discussed some correct base pins and I have found a correct one. I see what you about mean about getting one with out the pin.
Seems you tube has pulled all their videos on the old models for assembly/disassembly. So still doing my research before i take it apart. Thanks again for your help,Bill.
Chinook3
Re: Steel/Alloy ejection assembly ? Blackhawk
Posted: Mon Aug 26, 2024 3:50 pm
by flattop44
Oh, thinking a 44 FT, the alloy housing would be correct for the 1966 .41.
Bill
Re: Steel/Alloy ejection assembly ? Blackhawk
Posted: Tue Aug 27, 2024 3:09 pm
by Chinook3
Thank You!!