GKNR Single Six XR3 RED grip frame
GKNR Single Six XR3 RED grip frame
Looking for the regular size XR3 RED grip frame for a high-polish New Model stainless Single Six.
"My greatest fear is that, when I die, my wife will sell my guns for what I told her I paid for them." Anonymous Collector
Re: GKNR Single Six XR3 RED grip frame
Dremel and flitz can make that nausating high polish in a cuple hours or less on a grip frame, ask me how I know this.I have a SS XR3-Red off a Blackhawk I would like to send down the road
Re: GKNR Single Six XR3 RED grip frame
Intriguing offer, RocDoc. I could probably do that although I'd rather not spend the time and not sure I can match the finish. This is to restore a collectable piece that someone swapped out to a short grip frame.
Just in case, though, is it likely to fit up nicely on the Six? What are you asking for it?
Owen
Just in case, though, is it likely to fit up nicely on the Six? What are you asking for it?
Owen
"My greatest fear is that, when I die, my wife will sell my guns for what I told her I paid for them." Anonymous Collector
Re: GKNR Single Six XR3 RED grip frame
Came off an unfired NM Blackhawk I converted to bisley, fit to any cylinder frame may require a small tweek or two even though both factory. Just the slight differences within tolerances. I would take $85 flate rate priority shipped.
Re: GKNR Single Six XR3 RED grip frame
Sorry for ghosting you, RocDoc. Been a little nuts around here.
Great price and very tempting. Do the Blackhawk frames taper like the Single Six?
Great price and very tempting. Do the Blackhawk frames taper like the Single Six?
"My greatest fear is that, when I die, my wife will sell my guns for what I told her I paid for them." Anonymous Collector