Another display project from Taryn

[06dilly]

Got it, very nice. Makes such a clean display.

Thanks much, Rod!
TomD

[radicalrod]

I made so many of these all by hand and a pair of flat nose pliers.....
got done and my hands were blistered and bleeding.....
I bought the brass rod from Graingers ask for the bulk price as I got twice as much for less money.....

[06dilly]

Ok Rod, my first prototype…. It works but not sure I got it like you said.

TomD

[radicalrod]

Looks good I will try and post a picture of mine soon.

[JAYDAWG]

Looking good Tom!!
I do not have any ability or the patience to do something like that, good for you.
I have to buy mine.....

Cheers,
Jay

[RoninPA]

I use a similar system for my guns using Slat Walls. Sorry, don't have close up pictures (probably should do that to show the holders better)

[radicalrod]

Looking good Tom!!
I do not have any ability or the patience to do something like that, good for you.
I have to buy mine.....

Cheers,
Jay

That looks good and easy.....just how I like it
The hooks would have cost me more than the guns.....

[radicalrod]

My stands.....One 90 and one 45

[06dilly]

Love it, Rod. Even simpler. I’ll try that next. Also thinking to see if I can put clear tubing over the end and still fit it in a 22 cylinder.

Love the slat wall ideas, I just don’t have my entire room climate controlled enough to have guns out like that.

Jay, I’m almost 100% on purchased hangers also right now, just getting tired of buying more and more. Once you retire time is more available, so time to tinker.

TomD

[radicalrod]

you can adjust the droop of the barrel for different lengths by the angle of the end that fits in to the cylinder too.....
I have 10" 44's hanging on this same rod....